When the wing broke off of my Pigi 3d foam stunt plane in a crash I could have just glued it back on it would probably hold but I'm going to be using this plane for heavy 3d fly and I may need it to survive a couple more crashes so I am going to create some reinforcements along the inside of the wings. I will be doing this by cutting foam board from the Dollar Tree and allowing it to go inside the wings from one end to the other. There's no way to glue top and bottom from one side to the other all at the same time so I will cut the pieces and test fit them. Then glue one side slide the wing together and slice open the top of the wings and then glue the wing down to the strip. On the motor mount I'm going to glue it back in then add some reinforcement along the sides to help it be more stable
0 comments:
Post a Comment