Subscribe to:
Post Comments (Atom)
Popular Posts
-
When the wing broke off of my Pigi 3d foam stunt plane in a crash I could have just glued it back on it would probably hold but I'm goi... -
When I first bought this plane I did not have a landing gear it just had a bent piece of wire shoved into the bottom of the fuselage to slid... -
Now that the wing repair is complete the next part is the nose where the motor was broken off of the airplane. When the plane crashed I gat... -
I started by taking some measurements and test fitting some pieces into the front wing cavity. I wanted it to be a tight fit but not so tig... -
As you can see from the way the wing is constructed that there are only two vertical reinforcement bars and no horizonal reinforcement bars...
-
Here are a couple of Sony blogger camera mounts for the Super Cub made from the Dollar Tree quarter inch foam board. The hot glue gun holds ... -
I have always wanted to scratch build an airplane so I went to the hobby shop and priced out the parts it was going to cost almost as much a... -
After I installed the landing gear it raised the front of the plane up causing the rudder to drag the ground. I wanted it higher for the cl...
0 comments:
Post a Comment